Acumen Fireplace Remote Troubleshooting

How to Troubleshoot an Acumen Fireplace Remote Control

If you have a standard Acumen fireplace remote control and you can't get it to work with your fireplace, watch our video above or use these simple troubleshooting steps to get it working again.

Step By Step Guide

Acumen Battery Powered Receiver Box

1. Locate the Receiver Box

Most often, your receiver box will be located within the control cavity of your fireplace (seen in the image above). Check to make sure the wires are tightly secured to the terminals. If your fireplace and receiver box are both working properly, you should be able to slide the slider switch on the receiver box to the "On" position and your fireplace should turn on. If the fireplace does not ignite, you will need to either replace the nonworking remote control system or contact a gas plumber to further troubleshoot the fireplace.

 
Acumen Battery Powered Receiver Box and Remote Control

2. Remove the Batteries

Remove the batteries from your remote control. If your receiver box is battery operated, remove those batteries, as well. If you have not replaced the batteries recently, corrosion may have formed. This corrosion can prevent the system from operating, and you may need to purchase a new remote control system.

 
Acumen Battery Powered Receiver Box

3. Turn the Receiver Box to the Off Position

Once the batteries have been removed from your remote control and receiver box (if necessary), slide the receiver switch to the "Off" position.

 
Acumen Battery Powered Receiver Box

4. Re-Insert the Batteries

Once the receiver box is in the off position, re-insert new, fully-charged batteries into the receiver box. Next, slide the receiver switch to the "Remote" position.

 
Acumen Battery Powered Remote Control

5. Re-insert Remote Batteries

After batteries have been placed back into the receiver box, insert new, fully-charged batteries into the remote control.

 
Acumen Battery Powered Remote Control

6. Press the On Button

Once the batters have been replaced in both units, press any button on the remote control. We typically press the on button so the unit will light immediately to indicate proper function.

 
Acumen Dip Switches

7. Change the Dip-Switches

If the previous steps don't work, you can change the position of the dips switches on the back of the remote control to any position you like. Once the dip switches have been changed, repeat steps two through six.

Remotes with 110VAC Receiver Boxes

Acumen also makes remote control kits with 110VAC receiver boxes. If you're trying to troubleshoot that unit, simply remove the batteries from the remote and replace them back in and press the red power button on the 110VAC receiver. After that, press any button. Following these steps will get an Acumen remote control to work again.

Get Additional Assistance

If you need more help troubleshooting your fireplace remote system, feel free to contact us. Our team can help you get your fireplace remote working again. Alternatively, we’ll help you find the best replacement remote control system for your fireplace if one is available. We’re here to help Monday through Friday from 8 a.m. to 5 p.m. or any time via email.